iRemoval Pro Premium V3.1.1 User Guide

iRemoval Pro Premium V3.1.1 User Guide

Important Instructions

Note: Always download the latest version of the tool. Delete any old versions to ensure you’re using the most recent update.

Equipment Preparation

1. USB Cable: Use a reliable cable for a stable connection.

2. Internet Connection: A strong, fast Wi-Fi connection is required. Avoid using mobile hotspots.

3. iPhone Battery: Make sure your iPhone is charged to at least 40%.

4. PC Requirements: Use a Windows PC with at least Windows 10 installed.

5.  iOS Version:  Restore the iPhone to either iOS 17.7 or 18.0.1. Other versions are not supported.

6. iPhone Wi-Fi Settings: Do not connect the iPhone to Wi-Fi after restoring it.

Preparing Your PC

Disable Test Mode (if enabled)

1. Disable Windows Test Mode; by following the guide [here]

Disable Driver Signature Enforcement

1. Follow the guide [here]

2. Note: If you see a message, “The value is protected by secure boot policy,” disable secure boot from the BIOS menu. You can find instructions for your specific brand by searching online.

3. After disabling secure boot, repeat the steps to disable driver signature enforcement.

Set Up PC Drivers

1. Open 3uTools and uninstall iTunes from the Toolbox.

2. Restart your PC.

3. Reinstall iTunes from the 3uTools Toolbox.

4. Restart your PC again.

5. Go to Repair Drivers in the iTunes Utility inside the 3uTools Toolbox:

   - Select Advanced Repair.

   - Close the firewall and uninstall any old drivers.

Steps to Use iRemoval Pro v3.1.1

1. Open iRemoval Pro v3.1.1.

2. Connect the device without a SIM card and without Wi-Fi.

3. Click Activate.

4. Most users will see a successful activation. Enjoy!

---

Troubleshooting Common Errors

 1. "Failed to Activate: Contact Administrator"

   - Cause: Poor internet connection.

   - Solution: Ensure you have a strong internet connection and try again.

2. Tool Closes When Connecting iPhone/iPad

   - Cause: Likely due to firewall settings.

   - Solution: Download 1.1.1.1 from [https://one.one.one.one], install, and enable CloudWarp.

3. Error 0xF – iPhone Doesn’t Get Signal

   - Solution:

     1. Restore iPhone to iOS 17.7 or 18.0.1.

     2. Open iRemoval Pro v3.1.1

     3. Connect the device without a SIM card and without Wi-Fi.

     4. Click Activate.

     5. If you encounter Error 0xF, do not close the error window.

     6. Connect the iPhone to Wi-Fi.

     7. Click OK on the error.

     8. Click  Activate again.

     9. Enjoy – activation should be successful..

Thank you so much.. 

Credit to; Hardworking Block Mangi TECH iCloud and FRP Bypass Team.